SHOULD YOU HAVE ANY QUESTIONS, DO NOT HESITATE TO CONTACT US.

1. ESTABLISH A LOCATION WHERE BOARD IS TO BE MOUNTED.

2. DETERMINE HEIGHT OFF FLOOR TO BOTTOM OF BOARD. ADD 2 3/8", PUT LEVEL LINE ON WALL AT THAT HEIGHT. MAKE LINE SAME LENGTH AS BOARD. (i.e. 4', 6', 8' etc. wide) MEASURE UP 43 V2" FROM THE LINE YOU PUT ON THE WALL. (IF INSTALLING A 5' BOARD MEASURE UP 55 1/2") THEN MAKE ANOTHER LINE LIKE THE FIRST.

3. LOCATE VERTICAL STUDS IN THE WALL. STUDS ARE NORMALLY SPACED 16" OR 24" ON CENTER.

4. SECURE SCREW THROUGH LONG END OF MOUNTING CLIPS INTO STUD, ALIGNING TOP OF CLIP TO LEVEL LINE. USUAL PLACEMENT OF MOUNTING CLAPS IS ONE EVERY OTHER STUD-32" ON-CENTER.  RECOMMENDED SCREW SIZE IS #10 X 2" IN LENGTH. NOTE: IF MOUNTING ON BRICK, PLASTER OR CONCRETE WALL, INSTALL PLASTIC OR METAL ANCHORS AS REQUIRED INTO WALL. SCREWS AND ANCHORS CAN BE OBTAINED AT ANY HARDWARE OUTLET.